Using Your Forstner Klip

The Forstner Klip employs a beautiful ladder design and clasp that allows you to adjust the bracelet in micro increments for the perfect fit.  Even better, it has a very simple and intuitive interface that should take minimal (if any) practice to perfect.  The below instructions will help you hit the ground running with your new Klip band. 

Putting on the Bracelet:

These instructions will help you properly wear and size your Klip bracelet. 

First, with your watch on your wrist, pull on the clasp end of the bracelet to tighten until you reach your desired fit.  Once there, a "keeper" portion on the non-clasp end of the bracelet will lock the fit in place, making sure the bracelet does not loosen as you finish putting the bracelet on.  

Second, secure the clasp to one of the open slots in the bracelet.  The clasp of the Klip bracelet will be familiar to many, with its spring-loaded/push button system.  Once you've found the correct fit for your wrist, secure the clasp to one of the open slots by compressing the buttons visible on the clasp sides.  It clips in very easily, as shown in the below video: 

Removing Band:

To remove the band, unhook the clasp by pushing the buttons visible on the sides of the clasp.  However, the "keeper" portion on the non-clasp end of the bracelet will continue to keep your correct fit -- ensuring, for example, that the bracelet does not fall off accidentally.  To "unlock" the fit, let the clasp end of the bracelet hang loose while you extend the "keeper" portion from where it's locked in, as shown below:

Putting on and Taking Off:

The below video shows the entire motion in action -- both clasping on and taking off the bracelet. 

Please do not hesitate to contact us at support@forstnerbands.com if you have any questions!